Remote Start DIY Wiring Guide 2006-2010 Yaris - Toyota Yaris Forums

yarismadness · 11-24-2010, 09:36 PM

Very complete document! Thank you CTScott!

Now i can make some additions:

1- The parking brake switch (-) can be located in the Running Light Relay connector, light green cable, position 11.

2- For starters that have only one ignition output, I've chosen to connect my ignition output(+) to Ignition 2 (+ pink) , then link Ignition 2 to Ignition 1 with a 3Amps diode (white band towards Ignition 1 - green). I don't know if I could have link them together, but this worked. Attention: I didn't verify the current through the diode (as I should have), so I don't know if the 3Amps work for everybody on every condition.

3- I've find out a way connect a single start wire (+), and NOT NEED to override the clunch switch. Connect two diodes, one from your start wire (+), one diode to the starter wire (white band towards the starter - black wire ), and another from your start wire to the clunch connector (white band towards the connector - black wire )

the diodes I've used are the SB360 (schottky diodes, 60V 3Amps), almost any type of diode should do (OF THE RIGHT current!!!!!). If doubt, MEASURE IT!
They can be found at www.digikey.com

Good starting!!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW	VitzBoy	General Yaris / Vitz Discussion	7	09-20-2023 07:50 AM
Northeast DIY Remote Start / Keyless Entry Workshop - Sunday, October 26	CTScott	General Yaris / Vitz Discussion	51	11-10-2012 01:32 PM
2007 Yaris Pricing Info !	YarisBueller	New YARIS Purchase Forum	104	06-24-2009 04:54 PM
yaris sedan remote trunk relase question pls help soon	fantabulousbaby	New YARIS Purchase Forum	4	08-05-2006 01:26 AM

11-24-2010, 09:36 PM	#11
yarismadness Drives: Yaris 2007 hatchback 5 doors Join Date: Nov 2010 Location: montreal Posts: 2	Very complete document! Thank you CTScott! Now i can make some additions: 1- The parking brake switch (-) can be located in the Running Light Relay connector, light green cable, position 11. 2- For starters that have only one ignition output, I've chosen to connect my ignition output(+) to Ignition 2 (+ pink) , then link Ignition 2 to Ignition 1 with a 3Amps diode (white band towards Ignition 1 - green). I don't know if I could have link them together, but this worked. Attention: I didn't verify the current through the diode (as I should have), so I don't know if the 3Amps work for everybody on every condition. 3- I've find out a way connect a single start wire (+), and NOT NEED to override the clunch switch. Connect two diodes, one from your start wire (+), one diode to the starter wire (white band towards the starter - black wire ), and another from your start wire to the clunch connector (white band towards the connector - black wire ) the diodes I've used are the SB360 (schottky diodes, 60V 3Amps), almost any type of diode should do (OF THE RIGHT current!!!!!). If doubt, MEASURE IT! They can be found at www.digikey.com Good starting!!!