Pulling wires through the Yaris - Toyota Yaris Forums

gravylegs · 11-20-2006, 04:11 PM

This post is half question, half warning.

Yesterday I finally got around to pulling the power, RCA, and remote turn on wires from the battery/deck. The whole operation was fairly simple.

I pulled my power wire through an existing grommit hole on the passenger side floor. You pull back the carpet, then pull back the second carpet, then lift out the styrofoam floor piece (which I was suprised to find!), and there is a tube running from what looks like the HVAC right through the floor. I think it is an air intake. I put the wire outside of the grommit, and then wedged the grommit back into place holding the power wire snug. This was the only easily accessible hole in the firewall that I could find. My question here are: What is this tube? If it is an air intake, it is sorta scary that it is sucking my heating/cooling air in from the engine bay!

From here I pulled the wire over to the passenger side (pulled off the trim from the kick panel to the plastic panel that divides the front from the back) and ran it along the side of the car all the way through to the lift. My questions here: putting the trim back on the bottom of the door is really difficult! I had a REALLY hard time getting the carpet to hook back onto the clips that hold it in place, and then when putting the trim back on it simply will not clip back on. It stays in place nicely, but it definitely isn't right.
Any suggestions?

Stereo sounds sweet now...

Oh, and the warning part is "be careful when trying to put back the carpet and trim"

07WYarisRS · 11-20-2006, 04:40 PM

You ran the wire between the metal and the grommet?

Bad idea !

you are far better of drilling a hole for the wire or using an existing grommet with enough spce to poke another hole through.

vodkalush · 11-20-2006, 04:40 PM

From other post and readings I believe that the hose is used as an A/C drip hose (to lazy to look through the manual).

As far as the trim goes, double check and make sure that none of the "snaps" arent broken or bent. and try sliding it forward or backward to make sure that it is indeed in the right place

spkrman · 11-20-2006, 08:50 PM

best way is to drill a hole right next to the AC drain hose exit. Mine is temporarily jammed in there with the hose until I can find, or just break down and buy another unibit. When running 2/0ga wire it gets a little trickier hehe.

11-20-2006, 04:11 PM	#1
gravylegs Drives: 2007 Yaris Liftback RS Join Date: Apr 2006 Location: Toronto Posts: 35	Pulling wires through the Yaris This post is half question, half warning. Yesterday I finally got around to pulling the power, RCA, and remote turn on wires from the battery/deck. The whole operation was fairly simple. I pulled my power wire through an existing grommit hole on the passenger side floor. You pull back the carpet, then pull back the second carpet, then lift out the styrofoam floor piece (which I was suprised to find!), and there is a tube running from what looks like the HVAC right through the floor. I think it is an air intake. I put the wire outside of the grommit, and then wedged the grommit back into place holding the power wire snug. This was the only easily accessible hole in the firewall that I could find. My question here are: What is this tube? If it is an air intake, it is sorta scary that it is sucking my heating/cooling air in from the engine bay! From here I pulled the wire over to the passenger side (pulled off the trim from the kick panel to the plastic panel that divides the front from the back) and ran it along the side of the car all the way through to the lift. My questions here: putting the trim back on the bottom of the door is really difficult! I had a REALLY hard time getting the carpet to hook back onto the clips that hold it in place, and then when putting the trim back on it simply will not clip back on. It stays in place nicely, but it definitely isn't right. Any suggestions? Stereo sounds sweet now... Oh, and the warning part is "be careful when trying to put back the carpet and trim"

11-20-2006, 04:40 PM	#2
07WYarisRS HardlyDangerous Drives: 09 Yaris LE, H/B, auto Join Date: Jul 2006 Location: Ridgeway Ontario Posts: 573	You ran the wire between the metal and the grommet? Bad idea ! you are far better of drilling a hole for the wire or using an existing grommet with enough spce to poke another hole through. __________________ The early bird gets the worm, but the second mouse gets the cheese.

11-20-2006, 04:40 PM	#3
vodkalush I drive a yarrrris View User's Garage Drives: 07 Sedan Polar White Join Date: Sep 2006 Location: Rochester, NY Posts: 1,009	From other post and readings I believe that the hose is used as an A/C drip hose (to lazy to look through the manual). As far as the trim goes, double check and make sure that none of the "snaps" arent broken or bent. and try sliding it forward or backward to make sure that it is indeed in the right place __________________ Docotrs say all the drikning has mesesd up my seplilng and radieng Get your YarisWorld.com stickers here!!! The Official Toyota Thailand Accessories Order Thread will work for parts

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW	VitzBoy	General Yaris / Vitz Discussion	7	09-20-2023 07:50 AM
2007 Yaris Pricing Info !	YarisBueller	New YARIS Purchase Forum	104	06-24-2009 04:54 PM
I test drove a Yaris, Versa and FIT	CanadaCraig	New YARIS Purchase Forum	41	11-29-2008 09:18 PM
Toyota Yaris to Sponsor FOX's "Prison Break"	YarisBueller	General Yaris / Vitz Discussion	0	04-30-2006 08:01 PM

11-20-2006, 08:50 PM	#4
spkrman Banned View User's Garage Drives: 1 Join Date: Nov 2006 Location: 2 Posts: 1,476	best way is to drill a hole right next to the AC drain hose exit. Mine is temporarily jammed in there with the hose until I can find, or just break down and buy another unibit. When running 2/0ga wire it gets a little trickier hehe.