Bumper Vent

[TickleTimeTim]

Considering cutting a hole in my bumper where my bumper is cracked. The hole would go from body bend below headlight down to body bend just above fog light and about 4" wide. I would then put a metal frame on inside of bumper held on by 3m tape just for support, it would outline the hole. Then put some weather stripping (the kind everyone got from Home Depot and made a lip kit from) and place that over/around hole to make a smooth look. And finally run some black grill mesh behind it. It would pull air in, but since it is on the passenged side of the bumper, it would not be very functional since the washer fluid container sits just behind it. This is merely because i don't have the money for new bumper, was advised it's not worth fixing, and think it would be fun. Any advice?