 |
 |
|
|
03-14-2013, 03:23 PM
|
#1 |
  |
Address rubbing with DF210s
Ok. Installed DF210s and have some minor rubbing on the front.
Wheel/tire combo is 16x7; 205/50/16. I don't know the offset, but the tires are right at the edge of the fender well, not inside, not outside. The rear is ok and has minor rubbing only with major dips and I have set my Tokico reds to 2+ full hard to handle that. The front is another story with what's inside the fender well. I have heard of folks tearing out some part of their fender wells to help with rubbing issues, but I don't know exactly what they are tearing out. Any advice is welcomed. Pat |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rubbing Issues | RacerFreakXXX | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 7 | 05-12-2010 09:26 PM |
| Will Rubbing Occur on DF210's/ Motegi 17x7, ET40 with Nexen n3000 205/40ZR17 | areithan1980 | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 12 | 07-16-2009 11:52 AM |
| anyone rubbing with df210 on 205/45/17 | marcus | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 3 | 07-09-2009 11:59 AM |
| "Bouncy" Ride After DF210s? | MadMax | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 12 | 05-12-2009 11:04 AM |
| Rubbing: 185/60/15 w/NF210's | songa | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 10 | 12-10-2008 06:09 PM |
Threaded Mode