Can we do this? (aka The DIY Cruise Control Thread) - Toyota Yaris Forums

rhaagusa · 05-12-2010, 07:48 PM

Went by the dealer to get the proper screws which they didn't have, but found out they appear to be 5mm. I checked at Loews and 10/32 does fit loosely in a 5mm nut, but 5mm should fit right.
One more question please: While I was there he showed me a little pack of what I think was 2 black wires, and some zip ties. He said it was required, and it cost $12. At one end was the very small ends that go in the white clip type connectors, and at the other end of one was a screw down round tab type like used for a ground, that fits under a nut or screw head. Couldn't see the other ones end through the baggy packaging.
So anyway what are these wires and are they needed on a 2010 sedan automatic? If so where do they go and are there any directions and pics posted?
Hoping to only go in there once, so thanks very much, Robert

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag	CTScott	DIY / Maintenance / Service	307	04-04-2023 04:43 AM
DIY Cruise Control on 07-08 Yaris (step by step)	Vince87	DIY / Maintenance / Service	431	12-28-2020 02:37 AM
Cruise Control - Again!	CB900F2	DIY / Maintenance / Service	47	06-17-2010 07:29 PM
Cruise control vs MPG	YarisOwnersDad	Fuel Economy Forum	15	05-29-2009 04:55 PM
Using Cruise control	Driver	General Yaris / Vitz Discussion	14	11-09-2006 11:12 PM

05-12-2010, 07:48 PM	#11
rhaagusa Drives: 2010 yaris sedan Join Date: Apr 2010 Location: fort walton bch fl Posts: 9	Went by the dealer to get the proper screws which they didn't have, but found out they appear to be 5mm. I checked at Loews and 10/32 does fit loosely in a 5mm nut, but 5mm should fit right. One more question please: While I was there he showed me a little pack of what I think was 2 black wires, and some zip ties. He said it was required, and it cost $12. At one end was the very small ends that go in the white clip type connectors, and at the other end of one was a screw down round tab type like used for a ground, that fits under a nut or screw head. Couldn't see the other ones end through the baggy packaging. So anyway what are these wires and are they needed on a 2010 sedan automatic? If so where do they go and are there any directions and pics posted? Hoping to only go in there once, so thanks very much, Robert