crx rebuild

[ilikerice]

Ok, someone was asking how to figure out bearings using the coded numbers and colors.

Ill just do the rod bearings for now. Time is limited for me so this is going to be kinda quick. Sorry, I don't have time to put a slideshow up or video.

Pic 1 and 2: each rod has a number that is cut in half on the side of the rod bearing. by matching up the number you will get a 1-4. In my case I had 2-2-2-3.

Pic 3: on the crank there are letters stamped on the crank once by each in front of each rod journal. as U can see on the picture with the bearings and notebook, I had B-C-B-A.

Pic 5: using the chart here, basically you match up the number with the letter to get a color. So with my first rod bearing (2), I will go over 2 columns and then go down that column til I get to Row (B) and Yellow will be my color for which bearing I will need.

Pic 4: as you can see each bearing has a color on the side of it for easy verification.

Same thing as the crank, except the Letters for the crank are on the block where the rear main seal goes as shown in pic 6.

the numbers are on the crank and you can use the diagram in pic 5 to show you which numbers go for which journal.

Hope this helps a bit for the D16A6 builders