 |
 |
|
|
02-07-2010, 02:28 PM
|
#1 |
  Drives: 08 Yaris Sedan Join Date: Oct 2008
Location: California - Bay Area
Posts: 2,773
|
Issue for LP setting on 4 channel amp.
I have a mephis audio 4 channel amp. On my 3/4 channel i want to set it to LP frequency i have coaxials in the back. When i do i hear no sound. Even if i turn the gain up to max i barely hear a tiny gurgle. If i set it to full crossover then i get sound lows and highs.
One thing i know though is there was a issue with my neck. One of the channels was loosing ground the the installed took a piece of wire and wrapped it aorund one of the adjacent cables before plugging it into the back of the deck and it fixed the problem. Thus stealing the ground from the other channel. Could this be what is causing my problem? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bridging 4 channel amp | o2cavyss | In Car Entertainment + Electronics (audio / video / alarm) | 20 | 01-21-2010 04:40 PM |
| RMS capabilities | Slick | In Car Entertainment + Electronics (audio / video / alarm) | 31 | 08-21-2009 10:52 PM |
| My new deck and amp install plus question about fine tuning 4 channel amp.... | YarisSedan | In Car Entertainment + Electronics (audio / video / alarm) | 6 | 07-03-2009 01:37 PM |
| Quick advice needed on unfinished amp install | GreenSpeed | In Car Entertainment + Electronics (audio / video / alarm) | 15 | 01-16-2009 12:03 AM |
| Connect mono amp. + subwoofer to stock HU? | IsLNdbOi | In Car Entertainment + Electronics (audio / video / alarm) | 23 | 10-28-2008 11:01 PM |
Threaded Mode