|
03-31-2010, 01:31 AM | #1 |
Series/Parallel Config ?
Okay i got myself into a situation to where i can get two sets of these speakers (4 speakers total ) for a decent price. My amp does 87 rms so if i ran these in series parallel i could run these at 4 ohms i shouldn't have a problem with overpowering them would i ?
These are Audiopipes btw *3.5" Dynamic 2-Way Car Speaker *Max Power: 90 Watts *Rated Power: 45 Watts *Electroplated IMPP Dome Composite Cone *Electroplated PPTA Dome Tweeter *Impedance: 4 Ohms Sensitivity *Chrome Plated Tweeter Cover * Frequency Response: 100-20,000 Hz * Mounting Depth: 1.61" * 9 Oz magnet http://www.bcae1.com/spkrmlti.htm (Reference site ) This is a series/parallel connection (below). Connecting individual woofers in a series configuration is not common in car audio. This is a lot more common in musical instrument (guitar and bass guitar) speaker cabinets. I wanted to go with all Maxxonics products but....this deal was one i couldn't refuse.
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 Last edited by _S7V7N_; 03-31-2010 at 01:50 AM. |
|
|
|