 |
 |
|
|
01-09-2011, 11:52 AM
|
#2 |
  
|
Follow bottom radiator hose to block. It attaches to a plastic fixture behind which is the thermostat. You don't have to remove any hoses, just unbolt the fixture with hose attached and pull off, thermostat rests in the opening. Carefully remove to save the o-ring. I went with OEM replacement. You will have to drain radiator. Make sure you put the new one in the same way as the jiggle valve has to be in the 12 o-clock position.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| clutch replacement | vwtech | General Yaris / Vitz Discussion | 44 | 06-23-2017 02:06 PM |
| PCV Valve Replacement | devinlamothe | DIY / Maintenance / Service | 27 | 03-17-2013 12:06 AM |
| Single Tire Replacement - Using Pressure Sensor? | 1stOne | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 3 | 09-13-2010 11:25 AM |
| Parking Light replacement | Doug007 | DIY / Maintenance / Service | 1 | 11-06-2008 07:28 PM |
| TRD Thermostat | Jerkratt | Performance Modifications | 9 | 07-25-2007 10:39 PM |
Threaded Mode