Divorce forces me to modify the Yaris - Toyota Yaris Forums

bzinn 1 · 02-13-2012, 10:39 PM

I can take some more shots tomorrow since I gotta work swing shift.

I made out of angle aluminum two 5.5" brackets and mounted them through the floor with a bolt. The middle bolt is right in front of the carbon cannister,think that is what the black box is???? and the drivers side mounts about 8" over,there was a third mount but I cut that part off for the Flowmaster.

I am pretty sure that a canister exhaust would fit right beside this no problems as I only had to cut off 3.75 by like 12" piece to go around the exhaust.

The bumper edge was 3 bolts that went through bottom edge of the bumper.

I will get more shots tomorrow of it from underneath for ya.

I got it on Ebay under Universal Diffuser and it was the listing from think it was Neiland,WA and was $89 and shipping.It is well made,came with stainless hardware. The center two fins can be removed and are in there with built in threaded holes.....the aluminum mounts came from 1" angle piece from home depot cost was like $6.

My hardest part was the sub box was hard to work around,it is rivited to the floor and bolted so it is not gonna come out without several hours work...lol

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW	VitzBoy	General Yaris / Vitz Discussion	7	09-20-2023 07:50 AM
Natural Gas Yaris	MadMax	General Yaris / Vitz Discussion	13	06-03-2017 06:10 AM
2007 Yaris Pricing Info !	YarisBueller	New YARIS Purchase Forum	104	06-24-2009 04:54 PM
Florida Yaris Meet! 6/23/2007!	Sabretooth	Southeast	13	06-05-2007 06:46 PM

02-13-2012, 10:39 PM	#14
bzinn 1 Drives: 2008 Yaris HB Join Date: Oct 2008 Location: University Place,WA Posts: 828	I can take some more shots tomorrow since I gotta work swing shift. I made out of angle aluminum two 5.5" brackets and mounted them through the floor with a bolt. The middle bolt is right in front of the carbon cannister,think that is what the black box is???? and the drivers side mounts about 8" over,there was a third mount but I cut that part off for the Flowmaster. I am pretty sure that a canister exhaust would fit right beside this no problems as I only had to cut off 3.75 by like 12" piece to go around the exhaust. The bumper edge was 3 bolts that went through bottom edge of the bumper. I will get more shots tomorrow of it from underneath for ya. I got it on Ebay under Universal Diffuser and it was the listing from think it was Neiland,WA and was $89 and shipping.It is well made,came with stainless hardware. The center two fins can be removed and are in there with built in threaded holes.....the aluminum mounts came from 1" angle piece from home depot cost was like $6. My hardest part was the sub box was hard to work around,it is rivited to the floor and bolted so it is not gonna come out without several hours work...lol