 |
 |
|
|
10-24-2015, 07:11 AM
|
#1 |
  Drives: Toyota Yaris 1.33 SR Join Date: Nov 2014
Location: Italy
Posts: 42
|
Removing lower rear spring perches?
Hi guys, just had my Vogtland lowering springs installed two weeks ago after removing the Eibach ones that were too harsh to ride on. I noticed that both springs sets tend to leave the car higher in the rear (my wheelgap is two fingers in the front and two and half/three in the rear). I was thinking about removing the lower rubber perch in the picture below to make the car sit lower in the back. Is it possible or this will cause too much rattling/noise/damage?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW | VitzBoy | General Yaris / Vitz Discussion | 7 | 09-20-2023 08:50 AM |
| quick fix for bent rear axle/ hub? (please advise!) | tylerwatts53 | DIY / Maintenance / Service | 6 | 07-16-2014 08:20 PM |
| Rear spring swap info | The Spectacle | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 4 | 02-22-2009 10:37 PM |
| ideal spring rates for coil-overs on Yaris | botchilah | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 30 | 01-27-2009 05:24 PM |
| TANABE DF210 Spring Install [pics] | Chris07LB | DIY / Maintenance / Service | 148 | 07-16-2007 10:26 PM |
Threaded Mode