 |
 |
|
|
12-02-2015, 02:19 PM
|
#12 |
 Drives: 1sz fe Join Date: Nov 2015
Location: Minsk
Posts: 11
|
Checked pin2 EFI relay: 0 volt.
Pin5=12 volt. No depending on key position. Batt pin1 on ECU=12 volt. Pin7 on ECU grounded with key inserted. I've checked the wire from pin5 EFI to pin2ECU. It is ok. So, no any volts on pin1 of transponder, because it after EFI relay. Immo light flashing. Always. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| no start: engine immobilizer random issues | the_teach | DIY / Maintenance / Service | 4 | 04-13-2015 08:55 AM |
| Spark plug gap for 04 echo | donnysdayoff | DIY / Maintenance / Service | 2 | 01-16-2014 09:56 PM |
| viper 5901 replaced battery, crank but no start | yogi | In Car Entertainment + Electronics (audio / video / alarm) | 1 | 03-25-2013 09:15 PM |
| Worst Cars of the 2000s (#4. Echo) | MadMax | General Yaris / Vitz Discussion | 34 | 11-12-2009 11:41 AM |
| download for 2002 Echo Hatchback Owner's Manual | hoobyjuice | DIY / Maintenance / Service | 8 | 07-03-2009 09:28 AM |
Threaded Mode