Flashing dash when engine is OFF - Toyota Yaris Forums

klej89 · 03-21-2016, 02:55 PM

I do not have any modifications of the electrical system.
I know that on this pin should not be voltage with the engine off.

I have three basic problems:

1) On the back of the Instrument Panel J/B I have three sockets
https://onedrive.live.com/?cid=7E8AA...%21103&o=OneUp
In the schematic in the "2007 Yaris Factory Repair Manual" There are four sockets ...

2) I checked for continuity from pin 4 sockets 4F (Front Instrument Panel J/B) to pin 1 of a plug meter (MET 7.5A fuse was inserted) - there is no continuity (according to the scheme should be).

3) I can not remove the instrument panel because I can not unscrew the two bolts from the passenger air bag. For this reason, I do not have good access to Instrument Panel J/B and all the cables.

For these three reasons, at the moment I made a new wire to the power meter.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Zage Turbo Kit Install - Toyota Yaris	Focus_Sh1ft	Forced Induction Forum	160	02-06-2022 08:14 PM
p2138 engine code	crazylegs	DIY / Maintenance / Service	25	08-20-2020 05:40 AM
1kr-fe engine wiring	boothybunch	DIY / Maintenance / Service	0	03-28-2011 03:59 AM
Engine noise and Oil Lamp on	bieniman	DIY / Maintenance / Service	21	12-12-2010 11:47 PM
Info regarding Engine change.	sheraz2000	General Yaris / Vitz Discussion	5	01-08-2009 12:51 AM

03-21-2016, 02:55 PM	#7
klej89 Drives: Yaris Join Date: Mar 2016 Location: Poland Posts: 4	I do not have any modifications of the electrical system. I know that on this pin should not be voltage with the engine off. I have three basic problems: 1) On the back of the Instrument Panel J/B I have three sockets https://onedrive.live.com/?cid=7E8AA...%21103&o=OneUp In the schematic in the "2007 Yaris Factory Repair Manual" There are four sockets ... 2) I checked for continuity from pin 4 sockets 4F (Front Instrument Panel J/B) to pin 1 of a plug meter (MET 7.5A fuse was inserted) - there is no continuity (according to the scheme should be). 3) I can not remove the instrument panel because I can not unscrew the two bolts from the passenger air bag. For this reason, I do not have good access to Instrument Panel J/B and all the cables. For these three reasons, at the moment I made a new wire to the power meter.