2006 Yaris (2NZ -FE 1.3) - P0010 - Toyota Yaris Forums

bung206 · 03-19-2018, 03:33 AM

Ok - I replaced this sensor. It doesn't require removal of the alternator, it is actually quite easy.

The steps are:
1. Remove the black cover (the one with the VVTI Logo) at the top of the engine*(4 bolts)
2. Remove the metal bracket that holds the alternator to the top of the engine
2a. Maybe remove the connection plug for the injector if you need extra room and move the harness out of the way
3. Undo the bolt that holds the sensor in place (10mm) then take out the sensor.

As I was removing the sensor, I actually snapped off the black piece. Then when I grabbed onto the body and pulled it, the body came out but the actual sensor itself got stuck INSIDE the engine. I googled it and apparently THIS is also a common fault so please take care when removing yours.

I was able to remove mine by gently pulling it with vicegrips / pliers but you may not be as fortunate. One guy I found that had this problem had to remove his bumper and thread a bolt in there to remove it.

Take care when removing this thing.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW	VitzBoy	General Yaris / Vitz Discussion	7	09-20-2023 08:50 AM
fuel gauge disappeared, YARIS 2006, 1.3	toma	DIY / Maintenance / Service	10	05-06-2021 07:29 AM
fuel gauge disappeared, YARIS 2006, 1.3	toma	DIY / Maintenance / Service	0	10-29-2016 02:23 PM
how do I install a different headunit in 2006 yaris?	wouterw	In Car Entertainment + Electronics (audio / video / alarm)	10	05-13-2013 08:55 AM
2007 Yaris Pricing Info !	YarisBueller	New YARIS Purchase Forum	104	06-24-2009 05:54 PM

03-19-2018, 03:33 AM	#4
bung206 Drives: 2006 Yaris Join Date: Feb 2013 Location: New Zealand Posts: 12	Ok - I replaced this sensor. It doesn't require removal of the alternator, it is actually quite easy. The steps are: 1. Remove the black cover (the one with the VVTI Logo) at the top of the engine*(4 bolts) 2. Remove the metal bracket that holds the alternator to the top of the engine 2a. Maybe remove the connection plug for the injector if you need extra room and move the harness out of the way 3. Undo the bolt that holds the sensor in place (10mm) then take out the sensor. As I was removing the sensor, I actually snapped off the black piece. Then when I grabbed onto the body and pulled it, the body came out but the actual sensor itself got stuck INSIDE the engine. I googled it and apparently THIS is also a common fault so please take care when removing yours. I was able to remove mine by gently pulling it with vicegrips / pliers but you may not be as fortunate. One guy I found that had this problem had to remove his bumper and thread a bolt in there to remove it. Take care when removing this thing.