Installed the 1zz throttle body -

[thebarber]

Originally Posted by AlexNet0

how did you apply the gasket maker? To the Manifold side or the TB side?

im pretty sure i put it on the throttle body

to be honest, i wouldnt being doing this in the cold....im not sure how the gasket maker will set up when its as cold as it is right now....

when i did mine it was in sept of 2008....so it wasnt too cold yet

but for the record you SHOULD be disconnecting the battery when you swap tb's....itll reset the ecu so the car can relearn on the new tb. let it idle for about 10min and then youre off. also, not a mod id keep on the car in winter due to the high idle when the engine is cold...

[YarisPR]

Originally Posted by thebarber

im pretty sure i put it on the throttle body

to be honest, i wouldnt being doing this in the cold....im not sure how the gasket maker will set up when its as cold as it is right now....

when i did mine it was in sept of 2008....so it wasnt too cold yet

but for the record you SHOULD be disconnecting the battery when you swap tb's....itll reset the ecu so the car can relearn on the new tb. let it idle for about 10min and then youre off. also, not a mod id keep on the car in winter due to the high idle when the engine is cold...

I still have 1zz and still oscilates, its and Iddle malfunction. I have installed the stock one a few times and you HAVE to disconect the batery and before the installation of any of the TB. And as thebarber said it take about 10 min for the car to iddle rigth after you put the 1zz TB.