shaving the head down - Toyota Yaris Forums

06silveryaris · 04-08-2009, 09:43 PM

I have shaved many cylinder heads since I worked at a machine shop. Most heads have small markers indicating the limit before timing is affected. They are usually small circles on the intake end and on the exhaust end. They are usually not close to the chambers more like on the outer sides. You will see minimal gains by doing this, the only way to get a significant increase in compresion is by shaving a lot off but then it affects timing. Here it is very comon for people to shave .040 and is claimed to make good gain, which were noticable in the buttdyno. I shaved .160 on a hyundai excel that I owned, the thing revved like a sportbike but I had heating issues. Worked with the timing and all fixed out the increase was OK but not great. IMO got with higher comp pistons that is were there a real gain. The risk of clearance is not my major concern just damaging a perfectly good head is when the gain is so little.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fitting amplifier to Yaris head unit	nish1979	In Car Entertainment + Electronics (audio / video / alarm)	3	04-08-2009 06:18 AM
Changing LED's In Projector Head Lights	whooppee777	Cosmetic Modifications (Exterior/Interior)	16	03-01-2009 02:07 PM
Req: Head unit suggestions.	xed	In Car Entertainment + Electronics (audio / video / alarm)	21	08-09-2007 07:38 PM
Factory Head Unit	Kaotic Lazagna	In Car Entertainment + Electronics (audio / video / alarm)	6	05-11-2007 07:55 PM
human head in coffee beans	wushumasterku	Off-topic / Other Cars / Everything else Discussions	8	04-19-2006 11:39 PM

04-08-2009, 09:43 PM	#1
06silveryaris Drives: 2006 yaris Join Date: Oct 2008 Location: Puerto Rico Posts: 536	I have shaved many cylinder heads since I worked at a machine shop. Most heads have small markers indicating the limit before timing is affected. They are usually small circles on the intake end and on the exhaust end. They are usually not close to the chambers more like on the outer sides. You will see minimal gains by doing this, the only way to get a significant increase in compresion is by shaving a lot off but then it affects timing. Here it is very comon for people to shave .040 and is claimed to make good gain, which were noticable in the buttdyno. I shaved .160 on a hyundai excel that I owned, the thing revved like a sportbike but I had heating issues. Worked with the timing and all fixed out the increase was OK but not great. IMO got with higher comp pistons that is were there a real gain. The risk of clearance is not my major concern just damaging a perfectly good head is when the gain is so little.