I dropped something down in my parking brake slot... - Toyota Yaris Forums

supmet · 07-04-2009, 02:22 PM

I have a sedan, and to get under the ebrake -

1)Unscrew the bolts in the rear cup holder, you should be able to pop all of the trim off around below the cup holder.
2)open the center console, remove the rubber mat at the bottom, and take out the two bolts.
3)pop the bottom of the trim off under the a/c controls, and remove the 2 bolts under there.

You should then be able to pull the entire center console out. The power outlet by the ebrake might still be holding it in, but you should be able to move it around enough to get your ring. Also, when I did this, the purpose was to tighten the lid on the center console, which was popping up when I elbowed it. Tightening the four screws behind the cup holder fixed that problem.

Here's my loot from the adventure:

AlainMikli · 07-04-2009, 03:02 PM

Quote:

Originally Posted by supmet

Here's my loot from the adventure:

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The Basics on Brake Upgrades	kngrsll	Performance Modifications	56	03-06-2024 08:50 AM
DIY Rear Drum Brake Adjustment/Parking Brake W/ PICS Inside	YarisSedan	DIY / Maintenance / Service	73	03-11-2017 06:05 PM
DIY For radios that require attaching a wire to parking brake	Slick	DIY / Maintenance / Service	0	04-16-2009 08:14 PM
Parking Brake Adjustment Q's	Lafiro	DIY / Maintenance / Service	3	04-13-2009 08:19 PM
Parking Brake	Geelmeel	General Yaris / Vitz Discussion	3	06-07-2007 11:06 AM

07-04-2009, 02:22 PM	#1
supmet Banned View User's Garage Drives: 2007 4 Door Yaris Join Date: Jan 2009 Location: Southern California Posts: 1,357	I have a sedan, and to get under the ebrake - 1)Unscrew the bolts in the rear cup holder, you should be able to pop all of the trim off around below the cup holder. 2)open the center console, remove the rubber mat at the bottom, and take out the two bolts. 3)pop the bottom of the trim off under the a/c controls, and remove the 2 bolts under there. You should then be able to pull the entire center console out. The power outlet by the ebrake might still be holding it in, but you should be able to move it around enough to get your ring. Also, when I did this, the purpose was to tighten the lid on the center console, which was popping up when I elbowed it. Tightening the four screws behind the cup holder fixed that problem. Here's my loot from the adventure: