Triple C Design pod finished and installed

[anubisx99]

Originally Posted by k r a y z e e . j o j o

+2. This showed much promise, but I'm not too crazy about that size blocking the door and having to cut into it for the center gauge. Originally I was thinking you were building an exact replica of the one in the pics I posted in the initial thread. Sorry guys, have to pass on this (at least until it's redone)

as far as the hole, in the middle, I have explain this many times, the hole WE have is from our old setting, the holder is made to fit everything WITHOUT cutting into the cover, the original TRD (the one you got pics Krayzee) is closer to the glove compartment and I can guarantee you for that you'll HAVE to cut into it to make everything fit (unless the TRD gauges/tach is less than 1" deep, doubt it)...

[SilverBack]

Originally Posted by anubisx99

as far as the hole, in the middle, I have explain this many times, the hole WE have is from our old setting, the holder is made to fit everything WITHOUT cutting into the cover, the original TRD (the one you got pics Krayzee) is closer to the glove compartment and I can guarantee you for that you'll HAVE to cut into it to make everything fit (unless the TRD gauges/tach is less than 1" deep, doubt it)...

K I see what your saying now. What if you could just lengthen the center gauge section an inch or two so it's right above the steering column? There's plenty of dead space between the door and the wheel, and it should allow you to shrink the back of the pod just enough to open the door fully. What do you think?