 |
 |
|
|
|
|
08-04-2010, 04:52 PM
|
#1 |
 |
If the hub is hot or warm , the different expansion of two different metals , aluminium and cast iron , creates a welding effect on the centring hole.
A bit of grafite grease helps the next time around , if rust is a problem. I used to have a VW camper , which I had to loosen the bolts half a turn and take for a short ride on the flat to get loose 
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tire rotation: Does TPMS recognize tire position? | jcdrotos | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 17 | 03-17-2011 03:00 PM |
| Why does Tirerack reccomend 185/50R15s for seeminlgy ALL of their 15" rims? | St_G | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 15 | 03-16-2011 07:29 AM |
| Tire Size and FE question | GMKing | Fuel Economy Forum | 8 | 09-01-2009 10:20 PM |
| The Tire inflation debate... | Tankota | General Yaris / Vitz Discussion | 20 | 06-01-2006 08:09 PM |
Hybrid Mode
