Turbo clearance

[xbgod]

For those of you with space issues and thats pretty much all of you. After seeing the inside of your engine bays "not to mention that A/C line location" right in the way of everthing.

I'm working on or should I say in the process of helping someone with using a stainless flexable industrial line and fitting kit to move those pesky A/C lines out of the way but still utilize your factory mounting location. Basicly push your hard lines over by your ecu and run a industrial Stainless braided line with compression fittings to your stock mounting point. Then you have alot more room to play.

Here are a couple of pics that might interest you. first is the GT28R ss from Tial It's the same one I'm using but I have the GTX version which is just a redesigned billet compressor wheel. But for picture purposes it's the same. You can see that the stainless housing is small and compact and can fit in tight places. Also here is the new Tial BOV QR

QR is the more compact recirculating BOV. Optional 1.0" or 1.34" reciruclation port, uses the standard TiAL V-band flange and can be converted into a standard Q BOV by swapping the bottom piece.

Food for thought gentlemen.

XBG