AEM help

[Focus_Sh1ft]

Ok, first of all, what do you mean by this:

I did however use the Cam1 Magi-/Mago- to C20-121 instead of the Cam2 as written.

Do you mean you wired it up as I said to, but didn't include the Cam2 wires?

Next, did you intercept or tap the crank wires?

I'm thinking that most likely you're running pimp's tune with the wrong settings, most likely regarding the MAF. For example, if you try to run MAF in voltage mode and it sees a 0 in a cell, it's going to freak the hell out. Last I knew pimp was using some sort of MAF clamp, so it's very possible.

cdydjded is right though. You need to put in a blank tune and see how the car runs. The fact that the car runs fine with the bypass indicates the tune is PROBABLY the issue.

[Yoda]

Originally Posted by Focus_Sh1ft

Ok, first of all, what do you mean by this:

Do you mean you wired it up as I said to, but didn't include the Cam2 wires?

Next, did you intercept or tap the crank wires?

I'm thinking that most likely you're running pimp's tune with the wrong settings, most likely regarding the MAF. For example, if you try to run MAF in voltage mode and it sees a 0 in a cell, it's going to freak the hell out. Last I knew pimp was using some sort of MAF clamp, so it's very possible.

cdydjded is right though. You need to put in a blank tune and see how the car runs. The fact that the car runs fine with the bypass indicates the tune is PROBABLY the issue.

I intercepted the crank wires and yes I didn't include the cam 2 wires.... Should I have used them?