wiring after market speakers to an amp. - Toyota Yaris Forums

Domosofly · 04-11-2011, 03:36 PM

So if i wanted to hook up another amp how would i got about doing that? The amp would be a mono amp that supplies a 4 ohm load with 300 watts RMS, i would connect it to a single 12 inch sub woofer. Would i use a distribution block and just split 0 to 4 gauge, or is there a better way. And would having two amps end up dimming my lights and putting alot of strain on my alternator? I also have a amp running to my 4 door speakers, that delivers 50 watts.

Here are the amps.
1) Alpine MRP-M500
2) Alpine MRP-F300

thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inexpensive Amp + Sub; Checkin' the market...	kac	Willing to Buy by private party	7	08-13-2009 01:43 AM
Question about amp wiring	Arkhangel	In Car Entertainment + Electronics (audio / video / alarm)	8	03-17-2009 09:26 PM
Installing aftermarket componenet speakers and an amp in a LB	grampi	In Car Entertainment + Electronics (audio / video / alarm)	2	07-06-2007 07:49 AM
amp wiring question...	Keymaster	In Car Entertainment + Electronics (audio / video / alarm)	3	02-03-2007 10:01 AM

04-11-2011, 03:36 PM	#1
Domosofly Drives: 2009 Toyota Yaris Sedan Join Date: Apr 2011 Location: United States Posts: 8	So if i wanted to hook up another amp how would i got about doing that? The amp would be a mono amp that supplies a 4 ohm load with 300 watts RMS, i would connect it to a single 12 inch sub woofer. Would i use a distribution block and just split 0 to 4 gauge, or is there a better way. And would having two amps end up dimming my lights and putting alot of strain on my alternator? I also have a amp running to my 4 door speakers, that delivers 50 watts. Here are the amps. 1) Alpine MRP-M500 2) Alpine MRP-F300 thanks.