Autopower roll bars

[cali yaris]

^ that part went just fine. The rear braces, however, should have been a little narrower on the wheel wells (about a 1/2" on each side). Going to have to trim a fair amount out of the rear side trim pieces, which shouldn't be necessary. Not good on a customer's street car, but it is what it is at this point.

I don't mind tearing mine up to finish the install -- and onward we go. Pics to come.

[Jason@SportsCar]

Originally Posted by cali yaris

^ that part went just fine. The rear braces, however, should have been a little narrower on the wheel wells (about a 1/2" on each side). Going to have to trim a fair amount out of the rear side trim pieces, which shouldn't be necessary. Not good on a customer's street car, but it is what it is at this point.

I don't mind tearing mine up to finish the install -- and onward we go. Pics to come.

Every bolt in we have done required plastic trimming. You could try using a tie-down/come-along to pull the legs together while you mount it.