CVT drain / refill - Yaris 2007

[CTScott]

Originally Posted by tyrone_yaris

You mean that is the CVT filler port for the IKR FE and not the big bolt that is mentioned in the Micromanage link given below??

http://www.microimageonline.com/foru...T-Fluid-Change

I think it depends on the vintage of the CVT, and perhaps which vehicle it is used on as to if the fill port looks like the one above or the one in my DIY on MI.

[tyrone_yaris]

Originally Posted by CTScott

I think it depends on the vintage of the CVT, and perhaps which vehicle it is used on as to if the fill port looks like the one above or the one in my DIY on MI.

Ok so which fill port shld I use in my case, the black oval one or the one in your DIY at MI which I believe is the side bolt marked TC. (Pic attached)


Details of my car: Toyota Belta Year: 2007

1KRFE Engine, Chassis KSP92-BEXNK, CVFC ATM STEPLESS FLOOR SHIFT

Would appreciate if you could clear this confusion as it would help many out here in our country.

Thanks

Tyrone

[CTScott]

Originally Posted by tyrone_yaris

Ok so which fill port shld I use in my case, the black oval one or the one in your DIY at MI which I believe is the side bolt marked TC. (Pic attached)


Details of my car: Toyota Belta Year: 2007

1KRFE Engine, Chassis KSP92-BEXNK, CVFC ATM STEPLESS FLOOR SHIFT

Would appreciate if you could clear this confusion as it would help many out here in our country.

Thanks

Tyrone

Based on your model code, it would look like the bolt in the picture above, as opposed to the oval black cover.

[tyrone_yaris]

Originally Posted by CTScott

Based on your model code, it would look like the bolt in the picture above, as opposed to the oval black cover.

Thanks for your help. I guess the oval black cover is probably used to check the temp or quality of the fluid using a toyota probe.