Remote Start DIY Wiring Guide 2006-2010 Yaris

[camry09]

Can't seem to post an image with an url here, posts are being deleted

Sent you a PM

Thank you

[CTScott]

Originally Posted by camry09

Can't seem to post an image with an url here, posts are being deleted

Sent you a PM

Thank you

OK. I got the link to the document.

Your original questions were:

Trying to install Valet 561T in 2011 Prius Sedan AT with Factory Alarm

I think i figured out the most of the things except for few

On the 4 Pin Satellate Harness there are few wires that aren't clear for me where to connect

1. Accessory Trigger ( does it go to Conn 8 Pin 2 White wire)
2. Wire 3 Starter Trigger ( does that go to Conn D8 Pin 7 )

And another thing

Heavy Gauge Relay Sattelite

1. Wire 2 Purple do i tap in to D8 Pin 7 Black starter wires ?
2. Wire 3 Orange do i tap in to D8 Pin 2 White Accesory wire?


Accessory and starter trigger on 4 pin satellite are not needed.


On the heavy gauge one:

1. To Ignition 1 on the ignition switch connector.
2. To both black wires on the ignition switch connector.
3. To Accessory wire on the ignition switch connector.
4. To power feed on fuse panel
5. To Ignition 2 on the ignition switch connector. (You will also have to go through the configuration of the remote starter to select ignition, rather than starter function.
6. To power feed on fuse panel