Alignment specs for a 2008 Yaris sedan

[CoryM]

Originally Posted by yarisinoz

Can somebody tell me why the right rear toe is in red? The actual read should be inside the specified range isn't it?

The RR toe is in red because it is (barely) out of spec. Because the LR toe is pretty close to perfect, it most likely means that the RR has been bent. You would have to replace the torsion beam to correct it. That being said, your "total toe" is within spec, so it's probably not worth the $ to repair it. You shouldn't see any tire wear from it, but keep an eye on the inside edge of the tires for a bit.

Cheers.

[yarisinoz]

Originally Posted by CoryM

The RR toe is in red because it is (barely) out of spec. Because the LR toe is pretty close to perfect, it most likely means that the RR has been bent. You would have to replace the torsion beam to correct it. That being said, your "total toe" is within spec, so it's probably not worth the $ to repair it. You shouldn't see any tire wear from it, but keep an eye on the inside edge of the tires for a bit.

Cheers.

Thank you very much CoryM, it is strange as the car is a 2006 but I bought it with 23.900 kms in the odometer. I was not happy with the attention, that guy did not explain anything to me and it was the owner of the store. I got a better attention from one of his employees last week when I went there to fit new tyres.

Cheers