Yet another Foglight install thread - Toyota Yaris Forums

M4One · 05-26-2015, 10:06 PM

So I finally got around to installing the fog lights from Garm and as expected with my luck, they do not work. I connected the lights using yellow with yellow and the gray wire with the beige wire. The ground wire is tight and so are the connections to the fog light themselves. The only possible problem I might see is that one of the wires going into the fuse box came loose when I was installing them, but I clamped it back down and it should be okay.

Would it still be possible to install using a different method? What would happen to the wires that I use the splice connectors on?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Yaris Motor Swap Thread Read before posting swap threads	Sabretooth	Performance Modifications	219	06-10-2025 03:58 PM
Zage Turbo Kit Install - Toyota Yaris	Focus_Sh1ft	Forced Induction Forum	160	02-06-2022 09:14 PM
DC header, AEM cai and MI lightweight crank pulley install	aspro	Performance Modifications	7	09-02-2014 07:57 AM
2007 Sedan HU, Amp, Speaker install	Crackerballer	In Car Entertainment + Electronics (audio / video / alarm)	15	11-14-2011 08:47 PM
Yaris SR - JL Audio Install + Sound Deadening (Progress Thread)	Nips	In Car Entertainment + Electronics (audio / video / alarm)	8	03-18-2011 01:42 AM

05-26-2015, 10:06 PM	#12
M4One Drives: 2007 Toyota Yaris Hatchback Join Date: May 2006 Location: Vancouver, BC Posts: 110	So I finally got around to installing the fog lights from Garm and as expected with my luck, they do not work. I connected the lights using yellow with yellow and the gray wire with the beige wire. The ground wire is tight and so are the connections to the fog light themselves. The only possible problem I might see is that one of the wires going into the fuse box came loose when I was installing them, but I clamped it back down and it should be okay. Would it still be possible to install using a different method? What would happen to the wires that I use the splice connectors on?