Thinking about getting a yaris

[Frank the Tank]

Originally Posted by tmontague

This my recommendation w/ 1500 USD:

rear sway bar ~ $160
Micro Image lowering springs (can find these or other for $99)
Find a used intake manifold for around $100-150 or even ebay ones (avoid $300 brand new ones)
1ZZ throttle body used ~$50
Header ~$400
Intake Manifold ~$600 used (there was one on the classifieds here)
Custom header back exhaust w/ secondary cat delete 2-2.25" diameter ~$250

If my math is right the custom exhaust will put you over your limit. I would wait on rims. The stock 15's aren't that heavy and they'll eat up your cash.

Another big handling helper is getting aftermarket rims with an offset of around +30 to 35. This makes a big difference on a small car. I noticed a lrger handling difference when I added 10mm rear spacer with -1.2 degree camber washers.

So in terms of suspension, lowering springs on oem struts/shocks and a sway bar is all that's needed?

[sv650steve]

i was thinking the 1zz would be my best bet. How much could just afew welds really cost? I was thinking just 100 bucks. I'd do all the cuts. It sounds alot cheaper than $600.

[tmontague]

Originally Posted by Frank the Tank

So in terms of suspension, lowering springs on oem struts/shocks and a sway bar is all that's needed?

When cash flow is an issue yes. Ideally tokiko reds or blues are best