 |
 |
|
|
|
|
08-10-2016, 08:32 PM
|
#1 |
 Drives: 08 Yaris 3-Door Join Date: Jun 2012
Location: Saint Paul,MN
Posts: 10
|
Darn, I was hoping I just missed something while wiring because I didn't want to remove the system to return it. side note, how do I go about removing the ignition cylinder?
key->acc, push the pin, pull out 1/4". I know i'm suppose to remove the "key sense" but not sure if its the top right or bottom left. http://imgur.com/a/LJoW0 |
|
|
 |
| Tags |
| ignition cylinder, push start |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Engine Grille Block | BailOut | DIY / Maintenance / Service | 39 | 11-11-2017 10:33 PM |
| The Nitrous Thread | ChinoCharles | Performance Modifications | 116 | 02-16-2016 04:07 PM |
| 2009 Toyota Vitz/Yaris 1.3L hatchback Engine Heating Up | VitzBD | DIY / Maintenance / Service | 8 | 09-22-2015 08:01 PM |
| DIY: Intake Installation | redyaris | DIY / Maintenance / Service | 53 | 08-23-2014 06:34 AM |
Hybrid Mode
