 |
 |
|
|
11-26-2017, 12:29 AM
|
#2 |
|
やりすぎだ～
|
If the length of the threads of the new stud is 10mm longer than the original one then you're good.
The new stud length should at least make up for the thickness of the spacer. Dont confuse hub spacers with wheel spacers. |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Wheel Spacer Help 10mm | pinhead123 | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 3 | 11-25-2017 10:45 PM |
| Wheel bearing / Outer TRE / Control Arm replacement howto | shepd | DIY / Maintenance / Service | 3 | 09-14-2015 05:20 PM |
| Longer wheel studs for 5mm spacer? | Captain Slow | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 7 | 02-09-2013 11:35 PM |
| FS: Sparco Wheel, Quick Release, Momo Spacer | Focus_Sh1ft | Items for Sale by private party | 18 | 04-27-2011 01:36 AM |
| forged rims Vs. alloys | red-jdm | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 14 | 07-23-2007 09:30 PM |
Threaded Mode