Quote:
Originally Posted by Runethecursed
the main challenges is getting the sides to mate nice and neat with your curvature, the easy part is taping the centers together and going at it with some plastic weld and making sure its flat again
|
Very true. I was out this evening looking at it and I'm a little more optimistic about the outcome. The curved lines of the spoiler actually match almost perfectly with the contours of the grille. I am going to pick up some urethane caulk tomorrow and go up underneath to be sure it's strongly attached. Then , when it's set, I'll remove my screws. I'm going to use the ends I cut off and plastic weld them back on. Finally, the sanding, bondo,sanding, priming, painting and clear coat. A BIG job, but hopefully one that will be worth it.
__________________
2006 Yaris 5 Door RS 2ZR-FE (2011 Corolla 1.8L) Swapped, Automatic, T-28 Turbocharged (8 psi), HSD MonoPro Coilovers, DIY W/M Injection, custom 3" cold air intake, custom 2.5" exhaust, TRD rear sway bar, Penguin Garage 13mm spacers (rear), custom Civic front lip, full repaint, Android 6.0 7" touchscreen, Rockford Fosgate speakers, tweeters, NVX underseat subwoofer
https://www.instagram.com/2zr_turbo_yarisrs/
04-29-2018, 08:29 PM
Similar Threads
Hybrid Mode
