 |
 |
|
|
|
|
06-03-2018, 10:02 PM
|
#1 |
 Drives: 2007 Yaris Hatchback Join Date: Sep 2011
Location: Halifax NS
Posts: 11
|
I replaced the A/F ratio sensor today. I did it from underneath the car using a 7/8" torque adapter and a 6" extension. I used Seafoam Deep Creep and the sensor popped out without much effort.
I didn't have to remove or disconnect anything other than the sensor connector. The old sensor was covered in black soot. The codes haven't come back and car's been running very nicely. I will keep an eye on the fuel mileage for any improvement. |
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Used Oil Analysis - Yaris '08 144,000km | tmontague | DIY / Maintenance / Service | 10 | 10-30-2015 01:26 PM |
| My Oil Analysis 2007 hb 5 speed 123,994 miles | mark293 | General Yaris / Vitz Discussion | 12 | 02-25-2012 11:19 PM |
| Natural Gas Transportation - Why Not? | Kal-El | Off-topic / Other Cars / Everything else Discussions | 1 | 03-20-2011 02:12 PM |
| Question about a changing oil level | Goose | DIY / Maintenance / Service | 3 | 11-02-2010 11:32 PM |
| Synthetic Oil Questions. | Twistoffate0817 | General Yaris / Vitz Discussion | 19 | 07-15-2009 09:54 PM |
Hybrid Mode
