06YarisRS's 2ZR-FE Swap 5-Door Hatchback (Automatic Transmission)

[WeeYari]

How about knocking enough clip off to allow it to sit flat on grill. Epoxy a nylon bolt onto the back of badge. Tighten into grill with nylon nut.

Sent from my EML-L09 using Tapatalk

[06YarisRS]

Originally Posted by WeeYari

How about knocking enough clip off to allow it to sit flat on grill. Epoxy a nylon bolt onto the back of badge. Tighten into grill with nylon nut.

Sent from my EML-L09 using Tapatalk

Excellent suggestion WeeYari. Before reading this, I went out and attached the badge. As you suggested, I removed a couple of the clips. Then it would sit flush and stay put, but not strongly affixed. I put large globs of RTV sealant on the clips, then went around behind and applied more rtv, basically creating a big blob that connected all of the remaining clips. Since it's cold in my garage, I gently used my heat gun to warm the rtv. When this cures, the grill would come with the badge if pulled hard enough.

Here are a couple pics. Sorry about the quality. Crap camera and bad lighting.







Here's a better one taken outside.