 |
 |
|
|
|
|
|
|
||||||||
 |
|
|
Thread Tools | Display Modes |
|
|
02-25-2019, 08:58 AM
|
#1 |
 Drives: 2008 Yaris 3DR Hatch MT Join Date: Dec 2018
Location: Harrisburg, PA
Posts: 80
|
FWIW. With a linear taper pot, if you turn the pot halfway, the resistance measured on each side will be equal. With a logarithmic (aka "audio") taper pot the resistance follows a logarithmic progression.
Once you figure out the resistances that equate to throttle positions that you want, you could also consider a SPDT switch with hard wired resistors for "normal" and "highway" modes. Just a thought. Last edited by 2bz; 02-25-2019 at 10:46 AM. |
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blitz supercharger switch diagram | CrankyOldMan | Forced Induction Forum | 17 | 04-29-2019 01:56 PM |
| DIY yaris III fog lights installation | karloslatynos | Third Gen Yaris General Discussion | 53 | 11-12-2017 04:03 PM |
| eBay alert: great deal on a variable wiper switch | D&D | General Yaris / Vitz Discussion | 2 | 08-07-2013 11:56 PM |
| WTB variable wiper switch for my 08 sedan | CB900F2 | Willing to Buy by private party | 5 | 08-06-2013 10:43 PM |
| 3 Drive Throttle Contoller by NTD | Sabretooth | Performance Modifications | 31 | 10-07-2010 01:12 PM |
Hybrid Mode
