Crank Pulley

[Jerkratt]

i did mine without an impact gun... the only thing that was a bit** was the 128 lb torque (<---spelled it wrong) of the bolt holding the pulley. cause the pulley wants to spin while ur tryin

[eTiMaGo]

Originally Posted by Jerkratt

i did mine without an impact gun... the only thing that was a bit** was the 128 lb torque (<---spelled it wrong) of the bolt holding the pulley. cause the pulley wants to spin while ur tryin

LOL our engine's crank pulley is held in by more torque than it can produce

[kurokoma-kun]

I got the NST pulley and yes does it ever work!

I needed impact wrench to install.

Originally Posted by Jerkratt

the only thing that was a bit** was the 128 lb torque of the bolt holding the pulley. cause the pulley wants to spin while ur tryin

To prevent pulley from spinning while torquing the bolt, I just slipped a fat-ass screwdriver through one of the holes (there are several little places on the block to wedge the tip into). This worked MUCH better than shop rag looped through.