|
07-19-2021, 03:03 PM | #1 |
Drives: 2008 Yaris 3dr Join Date: Nov 2018
Location: Long Beach NY
Posts: 6
|
Remove alarm - Access to wires
Hello Everyone.....
Bought a used 2008 Yaris hatch. It came with a "Checkmate Model 100SPC" alarm system. Always hated having it. This morning I couldn't start my car. Had no startup issues prior to this morning. I put a multimeter on battery and it was only showing 9.95 volts. I likely just need a new battery but would love to take this opportunity to remove my alarm as well. It is now going off each time I re-connect the battery cables. I was hoping that if I looked under dash I would be able to cleanly extract the system and somehow reconnect standard harnesses.........I removed two sets of screws but only got as far as the picture below. Any tips on removing the next stage of dash??? I would at least like to be able see the wiring. I must say they did a good job of tucking everything up and away. Thoughts anyone? Should I just replace battery first? Thanks Pete Attachment 61809 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Zage Turbo Kit Install - Toyota Yaris | Focus_Sh1ft | Forced Induction Forum | 160 | 02-06-2022 08:14 PM |
Question replacing head gasket. | Snyprwlf47 | DIY / Maintenance / Service | 3 | 07-13-2014 11:17 PM |
DIY: LED side mirror installation | eTiMaGo | DIY / Maintenance / Service | 85 | 06-24-2011 11:48 AM |
Keep your vehicle protected! | sqcomp | In Car Entertainment + Electronics (audio / video / alarm) | 17 | 09-10-2009 02:02 AM |