|
08-21-2022, 05:49 PM | #19 | |
Drives: 07 AT & 08 MT Yaris HB 3dr Join Date: Nov 2021
Location: Alabama
Posts: 45
|
Quote:
I'm thinking that because you have both the console switch and the stalk switch, that might have something to do with the need for the additional ground. I have working fog lights now!!! |
|
08-23-2022, 09:15 PM | #20 |
Drives: 2007 5dr canadian import Join Date: Dec 2016
Location: pacific north WET
Posts: 1,025
|
i got my stalk out of pakistan so its probabably something about being a "euro" LHD stalk?....not sure, heck maybe the duralast just grounds that bit internaly for dual ground points..wouldnt be the first time ive seen aftermarket parts "shorten" the need for grounds internaly
my console switch needed a re-wire on the relay side to have them work together but that aside the ground was specific to the stalk i used |
08-24-2022, 09:24 AM | #21 | |
Drives: 07 AT & 08 MT Yaris HB 3dr Join Date: Nov 2021
Location: Alabama
Posts: 45
|
Quote:
|
|
08-24-2022, 09:42 PM | #22 |
Drives: 2007 5dr canadian import Join Date: Dec 2016
Location: pacific north WET
Posts: 1,025
|
im curious if the switches work the same....when i turn the headlights off it forces the fog section to turn and go off as well
|
08-25-2022, 06:16 PM | #23 |
Drives: 07 AT & 08 MT Yaris HB 3dr Join Date: Nov 2021
Location: Alabama
Posts: 45
|
|
10-05-2022, 05:28 PM | #24 | |
Drives: Luna Join Date: Sep 2021
Location: Ljubljana
Posts: 2
|
Quote:
regards Last edited by brownnick; 10-13-2022 at 01:31 PM. |
|
10-08-2023, 07:48 PM | #25 |
Drives: 2012 Sedan Join Date: Nov 2018
Location: New York
Posts: 21
|
Is the harness for the dash button also used for the stalk? I just bought a stalk and wanna make sure i get the correct harness.
|
10-09-2023, 05:41 PM | #26 |
Drives: 2007 5dr canadian import Join Date: Dec 2016
Location: pacific north WET
Posts: 1,025
|
|
10-11-2023, 01:43 PM | #27 |
Drives: 2007 Yaris Hatch Join Date: Sep 2019
Location: Maryland
Posts: 50
|
I bought my fog light stalk through the dealership. I think it was about $105. I did not have to do any wiring inside the car. Everything was just plug and play.
Eventually I wanted my fog lights to be turned on independently of the headlights. I also wanted the fogs to stay on with the high beams. So I removed the DRL relay under the dash and connected a the orange wire that (originally plugged into the DRL relay) to ground. |
10-16-2023, 04:19 AM | #28 |
Drives: yaris mk2 Join Date: Oct 2023
Location: Greece
Posts: 2
|
Hi guys, read all the posts around for fog lights installation but may my situation is a liitle different and I would like your help.
Installed the fog lights and now I am in the process of wiring installation. 1. The D4 Headlight Switch Assembly Connector under Steering column has no Orange and Yellow wire pins but White Gray Line and Yellow. 2. There is an installed Blue Relay, hope for Fog Lights but just found that is for rear fog lights (https://fuseandrelay.com/toyota/yaris-vitz-2g.html) 3. Fuse FR Fog Blue 15 is installed. 3. My Kit (see the picture) includes only 2 wires Black and Red except from Fuse,Relay and switch. Could you please tell me how to install in prewired? https://ibb.co/yffx6mJ https://ibb.co/FDJMZNL https://ibb.co/jG6sHm2 Last edited by nikoskdx; 10-16-2023 at 08:57 AM. Reason: Update |
12-19-2023, 03:23 AM | #29 |
Drives: 2009 Toyota Corolla Join Date: Dec 2023
Location: Kansas City, Missouri
Posts: 9
|
Since your headlight switch doesn't have the typical orange wire, I'd start by probing that white/gray wire to see if it gets power when the lights are on - that's probably your trigger wire.
As for your relay, I agree that blue one is likely for rear fogs. No need to change it though. Just wire your new fog lights to the normally open contacts on the relay coil side. Then run the trigger wire from the switch to power the relay coil. Ground the lights and relay coil obviously. You should be all set then! Lights will turn on with headlights. |
10-02-2024, 01:24 PM | #30 | |
Drives: 2012 Sedan Join Date: Nov 2018
Location: New York
Posts: 21
|
Quote:
On vehicles that have that pin wired in the harness, where does it output to? Meaning, if i want to copy the stock wiring, where would i have to run that wire and connect it to? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Zage Turbo Kit Install - Toyota Yaris | Focus_Sh1ft | Forced Induction Forum | 160 | 02-06-2022 08:14 PM |
2004 Canadian Echo Hatchback Fog light Kit ( OEM Style ) | mpcv2000 | Cosmetic Modifications (Exterior/Interior) | 26 | 04-06-2017 12:25 PM |
Driver side reverse light power issue | xdr3amx007 | DIY / Maintenance / Service | 1 | 03-22-2016 02:44 PM |
OEM Fog Light Brackets? | xavior686 | Cosmetic Modifications (Exterior/Interior) | 15 | 02-16-2014 12:04 PM |
2012 Yaris LE Check Engine Light On/Eco Light Off | 2012YarisLE | DIY / Maintenance / Service | 1 | 01-22-2014 11:29 AM |