|
03-06-2010, 01:07 AM | #1 |
HIFONICS ZXi6.5C ZEUS 6.5" 500W Component Car Speaker
When connecting a four channel amp to these you can run One channel to the Tweets and One channel to the 6.5 ( one set per door ) (so Two channels to the left door two channels to the right ) Correct without overpowering them. With the channel to the 6.5's on Full and the Tweets on High pass Correct? i'm just going with the Crunch 900.4 Here's the specs
# PowerZone Series 4-Channel AB Car Amplifier # RMS Power Rating: * 4 ohms: 57.5 watts x 4 chan. * 2 ohms: 112.5 watts x 4 chan. * Bridged, 4 ohms: 225 watts x 2 chan. # Dynamic (Peak) Power Rating: * 4 ohms: 115 watts x 4 chan. * 2 ohms: 225 watts x 4 chan. * Bridged, 4 ohms: 450 watts x 2 chan Component Specs 6-1/2" Component System Low Profile OEM-Fit Design Swiveling 12mm Neodymium Silk Dome Tweeters Moisture-Resistant Butyl Rubber Surrounds Ultra-Rigid Titanium Ceramic Composite Cones Chrome Raised T-Yoke High Mid Bass Impact CHrome Anti-Resonant Stamped Steel Basket 18 dB per Octave High Definition Passive Crossover Wide Nominal Power Range # Installation Hardware Included 100 watts RMS<-----Is this for each the 6.5 and Tweeter ? 500 watts Peak Frequency Response: 60 - 30,000 Hz Sensitivity: 91 dB 4 ohm Impedance Top Mount Dept: 2.44"
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-06-2010, 01:18 AM | #2 |
Or should i go with this one....It would almost hit the RMS and isn't much more than the Other.....900 is 74.95 The 1400 is 89 bucks..Free shipping on both.
# PowerZone Series 4-Channel AB Car Amplifier # RMS Power Rating: * 4 ohms: 87.5 watts x 4 chan. * 2 ohms: 175 watts x 4 chan. * Bridged, 4 ohms: 350 watts x 2 chan. # Dynamic (Peak) Power Rating: * 4 ohms: 175 watts x 4 chan. * 2 ohms: 350 watts x 4 chan. * Bridged, 4 ohms: 700 watts x 2 chan. # MOSFET power supply # LED power and protection indicators # Tuned Bass EQ (0-12 dB bass boost at 45 Hz) # Speaker-level inputs with soft turn-on # DC, short, thermal, overload protection # Illuminated CRUNCH logo # Variable high-pass filter (60-1200 Hz, 24 dB/octave) # Variable low-pass filter (30-250 Hz, 24 dB/octave) # Variable input level control: 0.2V-5.0V # Frequency response: 30-1,200 Hz # Dimensions: 13.38"L x10"W x 2.16"H # 4-gauge power and ground wiring is required for instal
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-06-2010, 10:38 AM | #3 |
Give Me Resonance
|
The rating is for the tweeter and mid. Get the second One if those are your choices
__________________
(3) 12" Alpine Type R Subs/Hifonics BXi1208D Hifonics ZXi6.5c / 2006 Kicker ZX350.4 Knu Fleks 1/0 Wiring & In Big 3 Optima Yellow Top Battery/Iraggi HO Alternator Alpine CDA-105, KCA-420i/KCA-121b/KCE-400BT PG TLD22 8V Line Driver |
03-06-2010, 12:24 PM | #4 |
Do you need the spacer on the door or do they slide right in without hitting the window ?
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-06-2010, 01:30 PM | #5 |
Give Me Resonance
|
id recommend a .5" or .75" spacer
__________________
(3) 12" Alpine Type R Subs/Hifonics BXi1208D Hifonics ZXi6.5c / 2006 Kicker ZX350.4 Knu Fleks 1/0 Wiring & In Big 3 Optima Yellow Top Battery/Iraggi HO Alternator Alpine CDA-105, KCA-420i/KCA-121b/KCE-400BT PG TLD22 8V Line Driver |
03-11-2010, 07:33 PM | #6 |
Question for Architect
Wow !!! These things are hellacious looking. I see they have -3 +3 or 0 db on the crossover connections, what is the best to use.
Did you run the power so the sub would illuminate ? The hifonics logo .
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-11-2010, 07:51 PM | #7 |
Give Me Resonance
|
0db is fine.
__________________
(3) 12" Alpine Type R Subs/Hifonics BXi1208D Hifonics ZXi6.5c / 2006 Kicker ZX350.4 Knu Fleks 1/0 Wiring & In Big 3 Optima Yellow Top Battery/Iraggi HO Alternator Alpine CDA-105, KCA-420i/KCA-121b/KCE-400BT PG TLD22 8V Line Driver |
03-11-2010, 08:23 PM | #8 |
What about the illumination ?
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-11-2010, 08:27 PM | #9 |
Give Me Resonance
|
I wouldnt even bother unless you intend of cutting out the plastic mesh on the door panel to see it/make it worthwhile
__________________
(3) 12" Alpine Type R Subs/Hifonics BXi1208D Hifonics ZXi6.5c / 2006 Kicker ZX350.4 Knu Fleks 1/0 Wiring & In Big 3 Optima Yellow Top Battery/Iraggi HO Alternator Alpine CDA-105, KCA-420i/KCA-121b/KCE-400BT PG TLD22 8V Line Driver |
03-11-2010, 08:47 PM | #10 |
I can't wait to get them installed, my amp should be here by monday, these things look sexy as hell. Where did you mount the crossovers ?
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-11-2010, 08:52 PM | #11 |
Give Me Resonance
|
down to the right behind the door panel with some ribbon sealer to hold it to the door.
__________________
(3) 12" Alpine Type R Subs/Hifonics BXi1208D Hifonics ZXi6.5c / 2006 Kicker ZX350.4 Knu Fleks 1/0 Wiring & In Big 3 Optima Yellow Top Battery/Iraggi HO Alternator Alpine CDA-105, KCA-420i/KCA-121b/KCE-400BT PG TLD22 8V Line Driver |
03-11-2010, 10:57 PM | #12 |
I think i'm going to show mine off, and figure somewhere to put them on the door panel facing us.
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-11-2010, 11:14 PM | #13 |
Audio Junky
|
keep the crossover away from the center of the car(in the front).... transmissions have a funny habit of inducing noise via the inductors (coils) found in crossovers.
|
03-12-2010, 10:50 AM | #14 |
They'll be mounted on the door, Do you happen to know if there's wiring in the door for the power windows and locks ? if so how many amps, i may just grab the power off one them to run the Logo Led's off the speakers.
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-12-2010, 03:57 PM | #15 |
Drives: Yaris HB Join Date: Jul 2007
Location: Central Alabama, GOD BLESS AMERICA
Posts: 755
|
would it be a bad idea to put the crossovers on top of the amp with some velcro to hold it in place?
|
03-12-2010, 05:09 PM | #16 | |
Audio Junky
|
Quote:
Keep in mind however, for every 10degrees you drop the operating temperature of an electric circuit... you double its life expectancy. |
|
03-12-2010, 11:05 PM | #17 |
They provide just enough speaker wire to run the speakers directly to the crossover if you mount it on the door, then all i have to do is run one speaker wire to the trunk where my amps going to be. I think i'm going to show off them crossovers they look kinda nice.
__________________
Audio is under Construction Kenwood KDC-X794 Hifonics Zeus ZXI6.5C 6.5-Inch 2-Way Component Speaker System - AUTOTEK ATX65CX 6.5-Inch Hifonics BXi 1210D - Crunch PowerZone P1400.4 (2)12 inch Kicker CVR's - 0 gauge from battery to Distribution block - 4 Gauge Power/Grounds to amps - Duralast Yellow Top - Big 3 |
|
03-13-2010, 09:49 AM | #18 |
Drives: Yaris HB Join Date: Jul 2007
Location: Central Alabama, GOD BLESS AMERICA
Posts: 755
|
Mount them visible on the inside of the door? With all the wires going into the door somewhere?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Photo-Scavenger Hunt - THE LIST | Black Yaris | Photo-Video-Media Gallery | 22 | 03-04-2009 08:35 PM |
YAR1S - Photo Scavenger Hunt! | YAR1S | Photo-Video-Media Gallery | 4 | 03-02-2009 07:44 PM |
Black Yaris - Photo-Scavenger Hunt | Black Yaris | Photo-Video-Media Gallery | 2 | 03-01-2009 04:13 PM |
Photo Scavenger Hunt Ideas Thread | Black Yaris | Photo-Video-Media Gallery | 41 | 02-28-2009 08:54 PM |
New car shopping - long post | littlecarlove | General Yaris / Vitz Discussion | 19 | 11-01-2006 10:58 PM |