Roof Drip Molding replacement on 2010 3D LB

[PinkPumba]

I'm trying to replace the LH and RH roof drip moldings on my 2010 Yaris 3D LB.

I purchased (2x) of 75551-52130 (same part used on both sides).
https://parts.toyota.com/p/Toyota__/...555152130.html

The LH molding went in fine but I can't get the RH molding to sit flat, it keeps lifting off the roof in the middle after I press it down.

Anyone else have struggles like this? I might just glue it down and be down with it :) or maybe try swapping the new LH and RH parts to see if that works.

The old RH molding didn't sit flat either and was bouncing/vibrating on the highway which is why I purchased a new one. Maybe the gap/flush is off on my Yaris from factory or from a previous owner accident.

Installation for reference (sedan but basically the same thing):
https://www.youtube.com/watch?v=TM_z...nel=burrheadjr

Thanks!