 |
 |
|
|
06-02-2010, 09:03 PM
|
#1 |
  
Drives: 2006 NCP91R, 1991 ST184R Join Date: May 2009
Location: Brisbane, Australia
Posts: 52
 |
Smaller diameter intake pipe = moar velocity?
So I was thinking, what if i changed my intake pipe (currently the stock 2.5ish inch rubber piece) to something with an ID of 2inch, and add a a bellmouth before the pod... would this increase air velocity, or would 2in be too small and harm performance?
edit: what the hell happened to the other post in this thread? Last edited by mick.wheelz; 06-02-2010 at 09:35 PM. |
|
|
|
06-02-2010, 11:44 PM
|
#2 |
|
1NZ-6spd
Drives: '05 6-Spd Vitz RS Join Date: Oct 2008
Location: Oshawa, Ontario, Canada
Posts: 2,967
|
You don't want to mess with the intake pipe Ø. The MAF meter relies on that Ø to meter the incoming air properly.
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Intake Installation | redyaris | DIY / Maintenance / Service | 53 | 08-23-2014 05:34 AM |
| The great intake debate! | fmicle | General Yaris / Vitz Discussion | 74 | 10-06-2009 11:37 PM |
| does BACK-PRESSURE increase MPG vs straight thru... | marcus | Fuel Economy Forum | 25 | 05-03-2009 09:23 PM |
| Intake Systems Decision Maker.. | Blenjar | Performance Modifications | 25 | 09-15-2007 10:07 PM |
| Exhaust Pipe Size (Tamaņo del tubo de escape) | carlosh | Central and South America | 11 | 08-02-2007 04:15 PM |
Linear Mode
