Group Buy - True Double Din Radio Trim for Liftbacks (180mm opening)

[WeeYari]

Originally Posted by IsLNdbOi

This is the best I could get it. The front bottom edge of the HU is flush / right up against the bottom edge of the new trim piece. The front top edge of the HU is further back so there's a small gap between that top edge of the HU and the top edge of the new trim piece. I'll have to cut the top edge of the stick on bezel that the Pioneer HU came with so I can stick that to the top edge of the front of the HU. Should take care of that gap.

I have a small gap at the top of mine which I was able to minimize to nearly un-noticable.

There is a small amount of up/down movement of the HU that can be realized via the 4 screws securing it to the dash assembly. Holding the HU in place with the 4 screws slightly loose, try sliding it up and down. You should notice that you will be able to raise the HU about 1/16".

Give it a shot.