Foot-light assembly on Yaris 2015 (Europe)

[eeeeeh]

Okay, finally done the wiring. End product looks like this.



1. Remove the front map reading light assembly. Solder a connector to these two locations. Of course use your multimeter or a simple lightbulb to test polarity.



2. Run wire from the assembly recess through to windshield, then under the roof lining and across to each A-pillar. Going around the airbag (do not obstruct) and through to under rubber seal. Run along and above the seal through to B-pillar.

3. Rear door rubber seal, you'd need to slit two holes to fit the flexible LED strip light through.



Something like this should suffice (the one I bought earlier no longer exist).

https://www.ebay.com.au/itm/Waterpro...YAAOSweNZa8V~u


Now my rear lights fade out just like the map light. (animated GIF)

https://imgur.com/jHOHeAA/


Since the hard part of wiring is done, I can now easily do the footwell light.