 |
 |
|
|
06-26-2009, 07:02 PM
|
#11 |
 Drives: 08 Yaris 3 door 5MT Join Date: Jun 2009
Location: Plattsburgh, NY
Posts: 7
|
Thanks CTScott that helps. So essentially I am running a wire from # 40 on ecm to the Positive on the switch setup. then ground out the switches.
There was a way to jump the clutch switch to see if the cruise works though correct? Also on the topic of clutch switch, I have to run wires from the switch to the pictured panel connector? Do I need as large of a wire with a fuse or would a regular wire work? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag | CTScott | DIY / Maintenance / Service | 307 | 04-04-2023 04:43 AM |
| DIY Cruise Control on 07-08 Yaris (step by step) | Vince87 | DIY / Maintenance / Service | 431 | 12-28-2020 02:37 AM |
| Cruise Control - Again! | CB900F2 | DIY / Maintenance / Service | 47 | 06-17-2010 07:29 PM |
| Cruise control vs MPG | YarisOwnersDad | Fuel Economy Forum | 15 | 05-29-2009 04:55 PM |
| Using Cruise control | Driver | General Yaris / Vitz Discussion | 14 | 11-09-2006 11:12 PM |
Threaded Mode