 |
 |
|
|
02-06-2010, 04:37 PM
|
#29 |
  |
was boosting 9 psi and yeah i do push the car very hard most of the time, often lingering at the red line limit.
well nevertheless the bearings would have to be replaced. hopefully the Toga bearings I purchased from IPP will perform. i wasn't able to locate a part number for our 1NZ from ACL and Clevite. if anyone here manages to do so appreciate if you could share. alright, i'll try to snap pictures of the crank as well, was thinking to keep the stock crank pulley though.
__________________
454 whp, 1.7 bar boost, pump gas, water/meth. 501 whp, 2.2 bar boost, pump gas + avgas, no water/meth. www.viosturbo.com - World's first 500 WHP 1NZ-FE |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Whistle at idle - vacuum leak, induction side | RichieRoo | General Yaris / Vitz Discussion | 17 | 12-16-2022 06:53 AM |
| TC swap? | MicroHB | Performance Modifications | 38 | 03-26-2009 01:39 AM |
| Induction with an Auto-Trans. | Sweet Mercury | Forced Induction Forum | 7 | 09-08-2007 04:15 PM |
| Engine mods - why bother? | RallyYaris | Performance Modifications | 143 | 12-24-2006 04:56 AM |
Threaded Mode