DIY Cruise Control FAQ (2006-2010 Yaris)

[carlosgil5]

Originally Posted by CTScott

Can you take a measurement on the wire that goes to the ECM pin. With the ignition on and none of the stalk switches pressed, it should read +12V.

I could not get any measurement I have one of those little harness plugs in the hole where pin 40 would be.

This are the connections under my steering wheel.
there's no blue and no brown wire.



This is my cluster showing the cc icons.


So I have to run the wire from which hole in the connector?

What else do I have to do, I already drilled the cover, plugged the stalk wire and bolted the OEM stalk.

I was really hoping my '10 AT had all the wires in place. Not at all.