 |
 |
|
|
04-21-2013, 12:44 AM
|
#11 |
|
advocatus diaboli
Drives: 07 Yaris hatch Join Date: Mar 2011
Location: San Jacinto California
Posts: 1,126
|
When you start adjusting your idle be sure to mark the adjusent screws original location before you begin. If you have to start from scratch you can back the screw out enough to completely close the flange(and choke/stall out the engine) then open it a little at a time until you get the idle you want.
This should be done at 180+ degree thermostat as the idle will drop when the water temp starts creeping up into 200. There is a whole world of issues when you add in a light flywheel/pullies and the 1zz.
__________________
-Type 07 FFL-  My odometer 03/11 http://i205.photobucket.com/albums/b...a/2843ed85.jpg |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| any person swap 1zz in yaris hb? | IVAN_TRD | Performance Modifications | 18 | 09-07-2014 12:19 PM |
| AFE short ram intake in 3rd Gen | DJYojimbo | Third Gen Yaris General Discussion | 10 | 12-20-2012 10:25 PM |
| Tanabe R&D Session on the 3rd Gen. | vitz_flava | Third Gen Yaris General Discussion | 2 | 06-07-2012 06:52 PM |
| 1zz swap...is it worth it??? | jouna | Performance Modifications | 12 | 11-10-2009 10:33 PM |
Threaded Mode