 |
 |
|
|
11-13-2013, 01:34 PM
|
#20 |
|
daily driver
|
if you turn the projector in the headlight you should be able to seat it so the cutoff is flat, no?
keep in mind, if you remove the bulb and look through the projector you can see the plate for the high/low beams....you should notice that everything will look upside down... in past, ive used a flashlight to set the projector angle in the headlight....just sit the headlight on a table flat as it would sit in your car...might require some propping aim it at a nearby wall and adjust the angle of the projector
__________________
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sedan HID Projector Retrofit Headlights | !yaris! | Cosmetic Modifications (Exterior/Interior) | 10 | 10-26-2017 02:31 AM |
| Voltage regulator and Amperage question... | cr.chango | DIY / Maintenance / Service | 13 | 11-24-2009 12:59 PM |
| ctrl-alt-delete question & free anti-virus question | Shroomster | Off-topic / Other Cars / Everything else Discussions | 18 | 09-08-2009 03:57 AM |
| Retrofit Question | ChinoCharles | Cosmetic Modifications (Exterior/Interior) | 19 | 05-13-2009 06:20 PM |
| Amplifier Watt Question....noob question | hasher22 | In Car Entertainment + Electronics (audio / video / alarm) | 4 | 09-27-2007 03:59 PM |
Threaded Mode