Baja Yaris

[myfirstyota]

Originally Posted by justjesus

I had two ideas for that. (1) Where the beam ties into the body, one bolt on each side if I recall. There are actually two bolt holes on either side. Some guys use the upper one once they've lowered the car some. I was thinking using those two bolt holes to make a simple bracket to drop the beam a small amount.

I also looked at the upper holes to use to mount some type of drop bracket. Now, I didn't spend an hour poking around down there but I didn't think the upper holes were threaded on the inboard side. And because of the way the "frame" is assembled, theres no access to the other side without cutting holes. Please tell me I'm wrong and that the upper holes are threaded on the inboard side (like the lower holes where the axle mounts from factory). If they are... drop brackets would be very feasable. But then I think, you axe some ground clearance by lowering the whole axle...