 |
 |
|
|
07-01-2021, 10:34 PM
|
#6 |
|
Average KKT User
Drives: 2001 Echo Join Date: May 2020
Location: Direct X Address
Posts: 41
|
Just my .02 cents just make sure you greased the caliper slide pins. Maybe the piston is stuck but I'd doubt that. I've never heard of hard to put in pads as being a problem as making them stick if they are stupid hard just grind the part of the pad where it contacts the caliper bracket makes it easier to get on and off if you grind too much it will just rattle a little. If they stick bad you will smell it.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Basics on Brake Upgrades | kngrsll | Performance Modifications | 56 | 03-06-2024 09:50 AM |
| DIY (sorta) - RunStop Rear disc brake conversion | eTiMaGo | DIY / Maintenance / Service | 17 | 07-02-2019 09:24 AM |
| Passenger side caliper loose... | baseballfan416 | DIY / Maintenance / Service | 5 | 08-17-2016 11:35 PM |
| Anyone care to make a DIY on break flushing and bleeding? | Hard_Yaris | DIY / Maintenance / Service | 19 | 05-04-2011 04:49 PM |
| Done! D2 Brake System, Tein Springs and H&R Wheel Spacers Installed | RedVitz | Photo-Video-Media Gallery | 18 | 10-09-2010 04:36 PM |
Threaded Mode