Jack Stand "Rubber Attachments"? - Toyota Yaris Forums

CTScott · 07-14-2009, 04:23 PM

Hockey pucks work great. I run them through the tablesaw a couple of times to put about a 3/8" wide by 1/2" deep groove in them.

schleppy · 07-14-2009, 04:24 PM

Quote:

Originally Posted by CTScott

Hockey pucks work great. I run them through the tablesaw a couple of times to put about a 3/8" wide by 1/2" deep groove in them.

+1 on this.

ExocetCom · 07-14-2009, 07:33 PM

Quote:

Originally Posted by CTScott

Hockey pucks work great. I run them through the tablesaw a couple of times to put about a 3/8" wide by 1/2" deep groove in them.

That's an awesome idea, thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rear point jack issue	bikegerm	General Yaris / Vitz Discussion	11	09-25-2024 02:55 AM
DIY: Aux Input Jack Adapter	TinyGiant	DIY / Maintenance / Service	11	11-10-2012 05:33 AM
DIY Aux Jack Install	Dave	DIY / Maintenance / Service	11	02-17-2010 10:15 PM
Jack Stands - GTA	CB900F2	DIY / Maintenance / Service	5	06-19-2009 06:56 AM

07-14-2009, 04:23 PM	#1
CTScott ULTIMATE View User's Garage Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008 Location: USA, CT Posts: 13,450	Hockey pucks work great. I run them through the tablesaw a couple of times to put about a 3/8" wide by 1/2" deep groove in them.